Answer:First: The difference is the surface.

 

L5010X is permanent marking tape with micro glass beads in bouth base material and the surface provide a good reflection and anti-slip effects.

 

L5020X is stain resistant marking tape with no glass beads,so its surface is smooth and easy to be cleaned up.

 

 

Second: the difference is applicable environment

 

L5010X is applicable to the place where demand for reflection.

 

L5020X is applicable to the place where high demand for cleanliness is requested.

Answer:Temporary marking tape not only used for short-term products but also for longt-term products.

 

Shour-ternm products  used as temporary change its rout changing which life 1 to 3 months when directly sticked to pavements based on different based on different pavement conditions and vehicle flows.

 

Long-term products used in indoor, outdoor pavements without vehicle running over. or various walls. which life can generally surpass 2 years.

Answer: It is the comon size which we have the products available. If

 

customer  order the particular size, we have to design and produce.

Answer: The pavement colorful sign adopt the preformed technique, with bright

 

color and never-faded. it Applicable to colorizing three-dimensional construction of road.

 

Repeated in indicating or warning with much less costly multiple signs than

 

standing-post sign.. It is easy to install and cleaning.

Answer: The products can be used in cold weather.Constructing with air temperature is above 5⁰C while road surface temperature is not lower than 10⁰C., when the temperature is low or the air is wet, you have to heat the pavement by a blowtorch or other baking equipements before installation.

 

When finish installing which follows the construction step, no cold wether or other factors effect the products.

 

Answer: Clean, dry and even pavement is requested. Wet pavement is forbidden.

 

The pavement must be fully dried for at least 24 hours after raining or snowing, No construction until the fog has disappeared and the pavement dried up in foggy days.

 

The asphalt pavement can be constructed after 10 days and the cement pavement is after 20days.

Answer:When the temperature is low or the air is wet, heat the pavement by a blowtorch or other baking equipment before construction.

 

When construct in winter, heat the wet pavement by a blowtorch or other baking equipments before installation.

 

Construction after snowing,frosting,fogging follow above article.

Answer:If there's bubbling phenomenon in the part of marking tape after pasting, it shows that the glue isn’t fully dried up and the air isn’t completely

 

emptied. Use a sharp tool puncture into the bubble and release the air ,then press the  products firmly again.

Answer:  There is crinkles or moving shows that the glue isn’t fully dry and the air isn’t completely emptied.

 

You could use a sharp tool such as knife puncture into the bubble and release the air,then press the pavement markings again.

 

Answer: we recommend to use temporary pavement marking tape(L1021X) or stain resistant marking tape (L5020X) with clean floor and no vehicle.

 

Answer: The main compositions of products is flexible polyment, with the strict management  for base material and technology it have bright vision and never-faded.

 

Answer: There have maintenance period. Generally speaking, auto cars could run

 

 over it after 20 minutes when permanent marking tape and contamination-

 

resisting pasting process is completed

 

When install temporary marking tape and car license, it just press it after

 

installation

 

Usually we should try our best to avoid tearing off by force within 24 hours.

 

Answer:  stir the adhesive thoroughly. Ensure the consistence is the same

 

. More strength is requested when gelatinizing to ensure adhesive and road

 

surface is well conglutinated.

 

 Please especially pay attention to the edge and corner of sign pattern where the glue must be completely gelatinized.

 

You could stick the marking tape during the second time brush as well as the glue

 

on the tape is in half-drying state and isn’t sticky to the skin. Should it was lain for

 

 a long time or the glue is dried up, you may proceed in doing second brush and

 

paste it when the glue isn’t sticky to the skin.

 

When used indoor or outdoor without vehicle, just need the first brush.

 

Temporay marking tape need not to brush the glue which used indoor and outdoor

 

 without vehicle.